Intellijel Designs uMIDI 1U

uMIDI is a MIDI-to-analog signal conversion module that provides the functions necessary to synchronize and control modular devices from computers, iOS devices, and MIDI hardware. No menu operation is required, and you can easily use the two buttons.

 The left section provides clock and transport related outputs. One of the clock outputs can be output at 1/16 and the other can be output at a specific number of divisions. Run and Reset outputs are patched to the corresponding inputs of the sequencer.

 The right section has one set of outputs needed to control a single voice via MIDI.

 Just plug in a MIDI cable or USB cable, LEARN the MIDI channel, and just play. If you send a MIDI note after pressing the LEARN button, uMIDI will convert and output the MIDI note on that channel. By holding down the LEARN button, the current MIDI channel and clock division number are memorized, and the settings are automatically recalled when the system is restarted.
 

• High-speed ARM processor for low latency
• MIDI input via DIN or USB
• Two clock outputs, one clock divide
• Supports bend and portamento and can accurately output 0-10V pitch signal
• Gate and trigger signals can be output separately
• Modulation wheel and CC output for additional modulation
• Firmware update via USB

 3U specificationsuMIDIIs equivalent to For the functions of each jack and button, see the product page for that.
 

Firmware Update

The firmware update procedure is as follows.

1. Power down the module and unplug all connected cables
2. Connect the USB cable to the computer from the back of the module.
3. IntellijelpageOpen the updater downloaded from and select the module and version from the dropdown.
4. LEARNHold down the button and power up the module again
5. At the bottom of the updaterUpdatePress the button to start the progress bar, and when the message “Update completed successfully” appears at the end, the update is completed
6. Restart the modular and it will work with the new firmware