Make Noise Dynamix
現在取り扱いしておりません
速いダイナミクスを持ったローパスゲート
Format: Eurorack
Width: 10HP
Depth: 24mm
Current: 55mA@+12V, 45mA@-12V
Manual pdf (English)
JACKS and KNOBS
PITCH KNOB
Input Jack
Input audio and CV to process with Dynamix
Signal Input Drive
Adjust the input gain to Dynamix. At 1 o'clock position, it becomes unity (unity gain), and if a modular level signal is input, it will give distortion to the signal after 3 o'clock
Dynamic Control
In the Dynamic control section, you can take audio as input and use the volume change to modulate the magnitude of the input signal. When the Attenuverter is set to the left from the center, the loudness of the input signal decreases as the dynamic input gets loud, and when the Attenuverter is turned to the right, the loudness of the input signal increases as the loud sound enters the Dynamic input. This produces an effect similar to ducking due to side chain compression. If you patch a signal with no volume change to Dynamic, you will not get any effective effect.
If not patched to the Dynamic input, the signal to the normal signal input will be patched to the Dynamic input.
Level Control
The output volume is controlled by the CV input to the Level jack. The level control knob below the jack acts as an attenuator, and the intensity of the input CV can be adjusted.However, with Dynamix, the tone changes depending on the output volume.If you change the intensity of the CV with this attenuator, not only the volume but also the tone Will change. If you want to change the output volume without changing the tone, adjust the Signal Input Drive knob.
The level jack is internally connected to 8V when not patched, so you can control the output volume manually. At this time, the tone also changes.
Output
CH 1 signal output
Channel 2
CH2 is the same as CH1
Aux Input
Audio and CV signals patched here will be mixed with the Mix output. Can also be used when mixing and mixing Dynamix and Optomix
Mix Output
Mix output where the input signals to CH1, CH2 and Aux are all mixed and output
When you move the cursor over the screen, the role of each part is displayed in a popup.
MUSICAL FEATURES
Dynamix is a low pass gate module that aims to respond quickly to CV. By using a circuit that uses transistors instead of the vactrol used in conventional low-pass gates, both frequency characteristics and volume (VCF / A) can be changed by CV. When audio is input to the DYNAMIC control, the signal can be used as a chain input again for ducking, etc. Dynamic has two such low pass gates, and it is possible to take out the mixed output. By mixing the output of another mixer (or another Dynamic module) into the AUX input, you can chain the mixer.
- Fast low-response analog low-pass gate function ideal for AM and ADSR level control
- Input gain adjustment function capable of mild overdrive
- Dynamic input that can also be used as a side chain input for ducking and expander functions
- It is also possible to process CV
- More channels can be mixed by chaining Dynamix or Optomix with Aux input