Erica Synths Pico Drums

Name: Erica Synths Pico Drums
Brand: Erica Synths
SKU: ERISYNPICDRUM0097
Price: 25900.0 JPY
Availability: InStock

Erica Synths

¥25,900 (税抜 ¥23,545)

2サンプル鳴らせパラメータ設定も強力なドラムモジュール！

Drum Sampler/Looper

Format: Eurorack
Width: 3HP
Depth: 35mm
Current: 35mA@+12V, 15mA@-12V
日本語マニュアル
 English Manual Page(pdf)

Quantity

在庫あり。15時までのご注文で即日発送します

MUSICAL FEATURES

Japanese manualThere is.

Pico DRUMS is a 12-bit drum module that can play two samples. 64 samples are stored,Drum ProgrammerIf you use, you can replace the sample inside.

Features and usage:

Play two independent drum sounds
The drum sound can be selected from 64 samples. Use the switch to select the channel for which you want to change the sample, push the encoder to turn off the light, and then turn it to switch the sample. Selected sample is indicated by LED combination
Pitch, decay and volume can be set for each channel. Use the switch to select the channel you want to set, and push the encoder to change the color. Green can set the pitch, red can set the decay, and yellow (orange) can set the volume.
Drum ProgrammerYou can upload your own sample at
Each channel can be triggered individually
Drum sounds of two channels are mixed and output
By setting the "EXCL" switch, the mode is set so that the drums of the two channels do not sound simultaneously (this is a common choke setting for hi-hats, etc.)
Playback is performed at 12 bits / 44.1kHz, producing a fat drum sound
For CV input, CH1 samplePitch, decay, volume, sample selectionCV control is possible for any of
Set the switch to CH1 and hold down the encoder for 2 seconds. After that, turn the encoder to change the color, so select the parameter you want to control with CV. Green is pitch, red is decay, and yellow (orange) is volume. When the color is off and six LEDs are lit, the sample is selected. After selecting the parameter you want to control, push the encoder to confirm.
When using CV control for sample selection, the sample changes in semitone steps at a CV of 1 V / Oct, so using a CV through a quantizer, etc., allows for accurate sample selection.
Up to six selected samples and parameter settingsSave and loadIs possible.
Set the switch to CH2 and press and hold the encoder for 2 seconds. When the encoder turns green and turns, the position of the glowing LED changes, so select the setting you want to load and push it to recall that setting. If you do not select a load and turn the encoder further, it will light red. At this time, you need to select the save destination. Select the save destination indicated by the position of the LED from six, and push the encoder to confirm the save.

TOP