Planar 2 is CV/ audio mixer of the many input and output that made the most of a characteristic of the joy-stick, パンナー. By unique operability of the joy-stick, I can perform a delicate and large number of control at the same time.
There are four to A - D in the input, and these are mixed with balance controlled with joy-stick, and it is output by MIX OUT. By this function with joy-stickIt is mixture cross fading with four signalsI can do it. In addition, a signal made individual アッテネート is output by output of A - D. The same signal of different アッテネート quantity can extract it from output A - D if I patch input only in A because it is connected the inside as for the input to the next input. ThereforeStereo / クアッドパンナーとしても use is possible. Because it is connected the inside, I can use 10V for input as quad controller (ABCD OUT) when I patch nothing. XY OUT always functions as simple X/Y controller regardless of input. Audio system, both CV can input each input.
In Planar 2 movement of the joy-stickRecordI was able to do it. Of the movement that is relatively slow in one-shot reproduction and a loop being possible as for the movement that they recordedEnvelopeやLFOとしても use is possible. When I revitalize the movement that I recorded, the movement of the real joy-stick is not reflected. Because overwrite by the punch in is possible; a positionJumpI can make the movement to do. I appoint it with a button in the timing of a start and the stop of a record and the reproduction, but trigger input can synchronize.
In addition, movement of the joy-stick became more fluent with 2. It is the controller that a slow delicate change is most suitable for necessary アンビエント.
Interface
The explanation of all parts is displayed in mouse over
DEMO
Firmware Update
The procedures of the firmware update are as follows.
I drop the power supply of the module
I connect a USB cable to a computer from the module back.
IntellijelのPageI open up the updater that downloaded から, and a choice does a module and a version from a drop-down.
ABCD buttonIn spite of being push, I spend the power supply of the module again
The retainer of the updater has itUpdateA progress bar begins when I push the button and is the update end if a message called "Update completed successfully" is displayed last
